In which mode do you display the desired position variable address?

Displaying the desired position variable address is appropriately done in TEACH mode. In this mode, a system or robot can learn from the user, allowing the operator to input specific data points, including position addresses. TEACH mode is specifically designed for programming and configuration, enabling the user to set up desired positions and movements that the system will later replicate.

In other operational modes, the focus shifts away from setting or teaching variables. For instance, EDIT mode allows for modifications to existing configurations or programs but is not typically used for displaying new variables. RUN mode is concerned with executing pre-defined tasks or commands rather than configuring them. Meanwhile, SETUP mode might involve initial system configuration but is also not primarily intended for displaying specific variable addresses.

Therefore, TEACH mode is the correct context for displaying and adjusting the desired position variable address, as it actively facilitates the teaching process of the system's positioning capabilities.